Data Link Connector - Replacement

24/05/96

86/06/96/US

SUBJECT:
Data Link Connector Housing (Damaged)

MODEL:
Range Rover 4.0/4.6

AFFECTED VEHICLES:
LP All
LH
LJ
LD

DETAIL

Presently if a data link connector (DLC), (J1962 connector), housing becomes damaged (located on the closure panel in the passenger footwell area) the complete harness has to be replaced. To avoid this lengthy process the DLC housing is now available as a separate item, which may be replaced if damaged.

ACTION REQUIRED

Should a DLC housing become damaged replace the connector using the process detailed below.

PARTS INFORMATION

STC3398 Data Link Connector housing

PROCEDURE





The DLC is located in the passenger footwell as shown in the illustration.

Procedure for replacing the data link connector.

1. Remove center screws from 2 scrivet fasteners. Release closing panel for access to DLC.

2. Carefully remove the DLC from closing panel.

3. Carefully remove the DLC housing from vehicle's harness and replace with new housing.

4. Refit DLC to closing panel and refit closing panel.

WARRANTY:

Normal warranty policy and procedures apply

COMP.CODE:

7Y1D

SRO:

86.70.86/32 - Data Link Connector housing renew 0.55 hr.





Wiring Key for the Data Link Diagnostic Connector.