Passenger Side

Service repair no - 76.73.69

WARNING: All the airbag system components, including the wiring harness, MUST be renewed after the airbags have deployed.

Remove
1. Disconnect both battery terminals, disconnect negative lead first.
2. Remove glove box assembly.
3. Remove veneered panel from passenger side of fascia.





4. Release and disconnect air bag module multiplug.
5. Remove 4 bolts and washers (E-10 Torx Bit) securing air bag module to fascia frame.





6. Carefully release and remove air bag module.

CAUTION: Store the airbag module correctly. See this section.

Refit

NOTE: If a new airbag module is being fitted the serial numbers must be recorded.

7. Carefully fit air bag module to fascia. Fit Torx bolts, and washers.
8. Tighten bolts to 9 Nm. (7 lbf.ft)
9. Connect air bag module multiplug and secure to location.
10. Fit glove box assembly.
11. Connect battery terminals, fit battery cover and secure with turnbuckles.
12. Check Supplementary Restraint System using TestBook.