SRS - Fuse Repalcement

NO. 76/15/94/US

DATE: 10/06/94

MODEL
Range Rover Discovery

AFFECTED VEHICLES
All derivatives with factory fitted SRS

SUBJECT
Supplementary Restraint System (SRS) Fuse Removal - SRS Lamp Illuminated

DETAIL

It should be noted that fuses 7 and 14 in the main fuse box are linked to the Supplementary Restraint System (SRS) circuit. If either of these fuses are removed while the ignition is on, a fault will be recorded in the SRS electronic control unit (ECU) and the SRS lamp in the instrument pack will be illuminated. To clear the recorded fault, the fuses must be replaced and the SRS system interrogated using Test-book and the fault cleared. Likewise if under normal operating conditions either fuse fails, the SRS light will be illuminated and the system must be checked using Test-book to identify the cause of the failure and to clear the recorded fault.

If the fuses have to be removed the procedure listed here must be followed.

ACTION REQUIRED

For information only. Follow the procedure listed prior to removing fuses 7 and 14.

PARTS INFORMATION

Not applicable.

PROCEDURE

1. Switch the ignition off and remove the ignition key.
2. Remove the lower fascia panel below the steering wheel to gain access to the main fuse box.





3. Identify the fuse to be removed, (see label inside fuse box).
4. Using the fuse extraction/insertion tool, pull out the fuse.
5. To insert the fuse, use the extraction/insertion tool.
6. Check to ensure the fuse is fully pushed in. The top face of the fuse should be flush with the others around it.
7. Ensure the correct value fuses are installed which is 10 amp for both fuses.

WARRANTY
Not applicable.

COMP. CODE
Not applicable

SRO
Not applicable