Tailgate Finisher - Blows Off In Car Wash
12/31/9676/28/96/US
SUBJECT:
PRIDE: Tailgate Finisher
MODEL:
Range Rover 4.0/4.6
AFFECTED VEHICLES:
L.P up to TA335523
LH
LJ
LD
DETAIL
The tailgate finisher on Range Rover models prior to VIN TA335523 can be blown off by some types of automatic car wash, which use high pressure air to dry the car. A redesigned tailgate finisher with a larger edge that improves the grip of the retaining clips is now available.
The repair procedures detailed below were developed as an element of the Land Rover Way OPERATION PRIDE. This TIB provides a library location for PRIDE information within the Land Rover North America technical literature system.
ACTION REQUIRED
Upon customer complaint for the symptoms outlined, Follow the procedure outlined below for the removal of the old finisher, the inspection of the retaining clips and the installation of the new tailgate finisher.
PARTS INFORMATION
AWR4314 - Tailgate Finisher (replaces AWR1603)
BTR6242 - Retaining Clips (if necessary)
PROCEDURE
Perform the diagnostic procedures and repairs outlined below for the repair of the tailgate finisher.
REMOVAL
Starting at one end of the finisher and working your way across, place your fingertips behind the finisher and carefully pull it out. The finisher can be removed with relatively little effort.
INSPECTION
1. Inspect the retaining clips and remove any broken clips by:
A. Sliding the retaining clip to the right until the semicircular edge of the locking tab is centered over the small silver stud on the tailgate (see illustration).
B. Insert a screwdriver behind the retaining clip, and carefully pry the clip loose.
If necessary, install the new clips by:
^ Inserting the top edge of the clip under the tailgate glass.
^ Center the semi-circular edge of the locking tab over the small silver stud on the tailgate and press firmly into place. Slide the clip all the way to the left to lock (see illustration).
INSTALLATION
To install the tailgate finisher, position the gripping edge of the finisher over the finisher clips and press firmly into place.
WARRANTY:
Normal warranty policy and procedures apply
COMP. CODE:
SRO:
76.43.75 Time 0.35 hr
Tailgate finisher renew.