Rear Window Trim - Loosens/Falls Off
12/04/9676/02/96/US
SUBJECT:
Rear Window Trim
MODEL:
Range Rover 4.0/4.6
AFFECTED VEHICLES:
LP Up to 335523
LH
LJ
LD
DETAIL
Two potential product concerns with the rear window trim are:
1. While washing the vehicle in an automatic car wash (high pressure brushless or blow dryer) the lower rear window trim may loosen and fall off.
2. The window upper trim finisher may not be fully installed.
ACTION REQUIRED
Follow the procedure below if either condition is found.
PARTS INFORMATION
AWR4314 replaces AWR1603 - Lower tailgate finisher (Qty. 1)
ALR6307 - Tailgate spoiler finisher (Qty. 1)
PROCEDURE
1. Completely remove the loose lower trim by carefully releasing the trim from it's retaining clips (6). Install the new trim (AWR4314), DO NOT use old trim finisher part number (AWR1603). The new trim part (AWR4314) has been introduced from VIN TA335523.
2. If a rear window upper trim is not installed correctly, find the loose points and push the trim onto the body until it is secure. New trim should not be needed, but if one is needed, carefully remove the old upper trim and install the new part making sure that it is securely fitted to the body at all points.
WARRANTY:
Normal warranty policy and procedure apply.
COMP.CODE:
9N1B
SRO:
76.43.75 - Remove and refit Lower Trim 0.25 hr
76.43.85 - Remove and refit Upper Trim 0.25 hr.