Front Output Shaft Drive Flange

Front Output Shaft Drive Flange

Service repair no - 41.20.15/01

Remove







1. Using LRT-51-003 to restrain front output shaft drive flange, remove and discard nut securing drive flange to front output shaft.
2. Collect washer and seal.







3. Using LRT-99-500 if necessary, remove drive flange from front output shaft.

Refit
1. Clean running surface of drive flange. Ensure all traces of rubber are removed.

CAUTION: Do not use a metal scraper as this may damage sealing surface.

2. Fit drive flange to front output shaft.
3. Fit seal, washer and new nut to front output shaft.
4. Using LRT-51-003 to restrain drive flange, tighten nut to 220 Nm. (162 ft. lbs.).