Bladder - Lumbar Support - Front seat - up to 99MY

Service repair no - 78.60.01

Remove
1. Remove front seat. Service and Repair
2. Remove head rest.
3. Remove head rest retainers by turning through 90° to release.





4. Remove 2 plugs from seat valance retaining screws. Remove 3 screws. Remove valance.





5. Remove 2 clips securing squab cover retainer to cushion frame. Release retainer.
6. Disconnect head rest and recline multiplug from connection under cushion.





7. Remove 4 bolts securing squab to seat. Remove squab.





8. Remove cover from arm rest screw. Remove screw and arm rest.
9. Remove 2 clips securing squab cover retainer to squab frame. Release retainer.





10. Release cover retention wires from frame. Roll cover back for access.
11. Remove 4 hog rings from front and 4 hog rings from rear of squab cover.





12. Roll cover back further. Remove 4 hog rings securing front of cover.
13. Disconnect remaining ends of retention wires.
14. Remove cover from frame.





15. Remove foam.
16. Disconnect lumbar motor multiplug.





17. Release 10 clips securing lumbar pump and bladder to frame. Remove pump and bladder.
18. Remove clips from pump and bladder.
19. Note position of 4 hog rings securing squab cover retention wire to front of bladder frame. Remove hog rings.

Refit
20. Reverse removal procedure.