Drive Cycle F

Testbook Drive Cycles

NOTE: Drive Cycle "F" is applicable to LEV's ONLY.

Drive Cycle A

* Ensure engine has not been run for at least 3 hours before beginning drive cycle.
* Switch ignition on for 30 seconds
* Ensure Engine Coolant Temperature (ECT) less than 60°C (140°F)
* Start Engine
* Engine idle for 2 minutes
* Hook up Testbook
* NOTE: If the SAI pump did not run during drive cycle, you must activate it using testbook (see testbook information on pump activation, follow route Petrol Engine, Sub System Test, Secondary Air Injection Test.)
* Check for fault codes