ABS Sensors - Rear

WARNING: If a sensor is removed for any reason, a NEW sensor bush must be fitted.

Remove
1. Raise the vehicle.

WARNING: Support on safety stands.

2. Remove road wheel.





3. Release sensor harness multiplug from clip. Disconnect multiplug.
4. Release sensor harness grommets from bracket. Withdraw sensor harness.





5. Remove 2 bolts securing sensor harness guard to axle. Release 2 harness clips from brake pipe.
6. Clean area around sensor to prevent ingress of dirt.
7. Using a suitable lever, prise sensor from bush.





8. Remove sensor/harness assembly.
9. Remove seal and bush.
10. Clean sensor location.

Refit
11. Lubricate new sensor bush with silicone grease.
12. Fit sensor bush and seal.
13. Lubricate sensor with silicone grease.
14. Push sensor fully into bush until it contacts reluctor ring. Correct sensor position will be gained when vehicle is driven.
15. Position sensor harness guard. Secure with bolts.
16. Engage sensor harness guard clips to brake pipe.
17. Thread sensor harness through grommets. Engage grommets in bracket.
18. Connect multiplug. Secure in clip.
19. Fit road wheel, tighten nuts to 108 Nm (80 ft. lbs.).
20. Remove safety stands. Lower vehicle.
21. Clear ECU error code using Testbook
22. Carry out short road test to ensure that ABS warning light remains extinguished.