Wiper Motor and Linkage

Wiper Motor and Linkage

Service Repair No - 84.15.11

Remove
1. Remove air intake plenum.
2. Remove covers from wiper spindles.
3. Remove nuts and flat washers securing wiper spindle housings.





4. Disconnect screen heater multiplug. Release multiplug clip from scuttle side panel on driver's side of vehicle.
5. Remove 6 bolts securing scuttle side panel. Remove panel.





6. Disconnect multiplug from wiper motor.





7. Remove 2 bolts securing wiper motor to scuttle. Remove wiper motor/linkage assembly.

Refit
8. Position wiper motor/linkage assembly. Fit bolts loosely securing motor to scuttle panel.
9. Position scuttle side panel. Secure with bolts.
10. Connect screen heater multiplug. Secure multiplug clip to scuttle panel.
11. Secure wiper spindle housings to scuttle with nuts and flat washers. Tighten to 11 Nm (8 ft. lbs.)
12. Tighten motor securing bolts to 7 Nm (5 ft. lbs.)
13. Connect multiplug to wiper motor.
14. Fit covers over wiper spindles.
15. Fit air intake plenum.