Suspension - Correct Ball Joint Splitter Usage
No: LTB00248Issue: 1
Date: 17 DEC 2009
SECTION: 204
Correct Procedure for Ball Joint Splitter Use
AFFECTED VEHICLE RANGE:
All
CONDITION SUMMARY:
Situation:
For information only, informing the Authorized Retailers of the correct procedure for using the Ball Joint Splitter (tool number 205-754A).
Action:
In the event it becomes necessary to use the Ball Joint Splitter (205-754A), refer to the Service Procedure outlined below.
PARTS:
No parts necessary; information only
TOOLS:
205-754A .................Ball joint splitter
Normal warranty policy and procedures apply.
SERVICE PROCEDURE
CAUTION:
Do not use air tools.
1. Ensure ball joint splitter (205-754A) is correctly fitted to the ball joint.
^ To allow for equal loads during operation, ensure the ball joint splitter is set so the top and bottom sections are parallel. ((4) Figure 1)
CAUTION:
During operation, the ball joint may be displaced from the vertical link and the ball joint splitter may be separated from the ball joint.
2. Tighten the ball joint splitter forcing screw to 60 Nm (45 lbf ft). ((3) Figure 1)
CAUTION:
During operation, the ball joint may be displaced from the vertical link and the ball joint splitter may be separated from the ball joint.
^ If the ball joint has not been displaced, use a suitable tool and strike the top of the ball joint splitter ((1) Figure 1), introducing a shock to displace the ball joint.