Campaign - Front Power Windows Inoperative
No: H282Ref:
Issue: 1
Date: 11/22/02
SERVICE ACTION
Inoperative Electric Windows
AFFECTED VEHICLE RANGE:
Freelander (LN) 2A333058 to 2A386262
SITUATION:
ELECTRIC WINDOWS DO NOT OPERATE
The customer may complain that the front electric windows no longer operate. The window lift fuse may have blown.
RESOLUTION:
UPGRADE FUSES AND IF INDICATED INSTALL NEW SWITCHES
Replace the window lift fuses with higher capacity fuses.
PARTS INFORMATION:
YQ5000271 Fuse label Qty 1
LRN0002LABEL Campaign Label Qty 1 (NOTE: Sold in quantity pack of 100)
LRL0442NAS1 Handbook page Qty 1 (NOTE: Sold in quantity pack of 20)
One package included free of charge in this mailing. Reorder as required.
Locally Sourced
^ 25A Fuse Qty 2
WARRANTY CLAIMS:
H282 (Option B) Time: 0.10 hrs
Inspect and upgrade window lift fuses
Normal warranty policy and procedures apply. Material allowance is included in labor operation.
REPAIR PROCEDURE
INSPECT AND IF INDICATED INSTALL NEW WINDOW LIFT FUSES
1. Inspect both fuse 33 and fuse 34 to determine if 25 amp fuses are installed.
2. If a rating other than 25 amps is found, replace fuse 33 with locally sourced 25A blade fuse.
3. If a rating other than 25 amps is found, replace fuse 34 with locally sourced 25A blade fuse.
4. Verify that the windows function normally.
NOTE:
If the problem persists after fuse replacement, investigation of the window lift circuit including the window switches will be required to determine the source of the problem.
5. Install new fuse box label (YQS000271) containing the revised rating over the existing label.
6. Open the Owners Handbook to page 168 and mark through the table of fuse information on that page.
7. Insert a revised Owners Handbook page 168 replacement sheet into the handbook covering the marked through page.
INSTALL CAMPAIGN LABEL
NOTE:
Campaign labels may have multiple Campaign numbers written on them if multiple campaigns are performed at the same time.
1. When all specified repairs have been accomplished, prepare the campaign label (LRN0002LABEL) as follows:
a) Place the label on a hard surface.
b) Use a ballpoint pen to neatly write/scribe in the bare aluminum areas of the label the following information:
^ Service Action code "H282"
^ Your retailer code
^ The date of repair
2. Clean all grease and dirt from the radiator support member.
3. Peel the completed campaign label from the backing paper and position it on the cleaned area.
4. Roll the label with the special roller tool to ensure proper adhesion.