Housing Assembly HVAC: Service and Repair
Heater AssemblyService Repair No - 80.20.01
NOTE: This procedure has been updated as per Land Rover technical bulletin 80/01/06/NAS
1. Clamp the heater matrix supply and return hoses.
2. NOTE: A small amount of fluid loss is unavoidable; position an absorbent cloth or container to collect it.
Release the two clips securing the heater hoses to the heater and release the hoses.
3. Remove the fascia.
4. Remove the two bolts from console support bracket release the two relays and remove the bracket.
5. Disconnect the four electrical connectors from the heater controls.
6. Disconnect the electrical connector from the heater and release the diagnostic socket.
7. Disconnect the electrical connector from the evaporator.
8. Remove the bolt from the duct of the left-hand outer face level vent and release the duct from the heater.
9. Remove the bolt from the duct of the right-hand outer face level vent and release the duct from the heater.
10. Release the duct of right-hand demister vent.
11. Release the duct of left-hand demister vent.
12. Release the air inlet electrical connector hose.
13. Release the harness from the two clips on the heater.
14. NOTE: Do not carry out further dismantling if the component is removed for access only.
Remove the two nuts and one bolt securing the heater to the body and remove the heater.
15. Disconnect the two electrical connectors from the heater controls.
16. Release the air blend control cable from the lever and abutment.
17. Release the air distribution cable from the lever and abutment.
18. Remove the heater controls.
Install
19. Position the heater controls to the new heater.
20. Connect the air distribution cable to the lever and abutment.
21. Connect the air blend cable to the lever and abutment.
22. Connect the electrical connectors to the heater controls.
23. Install the heater and secure with the nuts and bolt.
24. Position the wiring harness and secure with the clips on the heater.
25. Install the air inlet electrical connector hose.
26. Install the right-hand demister vent duct to the heater.
27. Install the right-hand outer face level vent duct to the heater and secure to the body with the bolt.
28. Install the left-hand demister vent duct to the heater.
29. Install the left-hand outer face level vent duct to the heater and secure to the body with the bolt.
30. Connect electrical connector to evaporator.
31. Connect the electrical connector to the heater and secure the diagnostic socket.
32. Connect the electrical connectors to the heater controls.
33. Install the console support bracket and secure with bolts.
34. Install the relays to the console support bracket.
35. Install the fascia.
36. Connect the heater hoses and secure with clips.
37. Remove the hose clamps from the coolant hoses.
38. Top up coolant as necessary.
39. Remove container from beneath the vehicle.