Front Fender: Service and Repair

76.10.24 Wing - Front

Remove

1. Remove front mud flap.
2. Remove lower sill finisher.







3. Remove 4 bolts securing rear of front wing.







4. Release wheel arch liner from rear of front wing.
5. Remove 2 bolts securing wing bracket to 'A' post.







6. Remove 4 bolts securing top of wing.
7. Remove bolt securing front of wing to bracket on body.
8. Remove screw securing wheelarch liner to under side of wing.
9. Release wing from body and disconnect multiplug from repeater lamp.
10. Remove front wing from body.
11. Remove side repeater lamp from front wing.

Refit

1. Fit side repeater lamp to front wing.
2. Position front wing to body.
3. Connect repeater lamp multiplug.
4. Align front wing to body.
5. Fit bolts securing rear wing to 'A' post, top of wing and front of wing, but do not tighten at this stage.







6. Align wing and tighten bolts in sequence shown to 5 Nm (3.5 lbf.ft).
7. Align wheel arch liner to rear of wing.
8. Fit screw securing wheel arch liner to under side of wing.
9. Fit lower sill finisher.
10. Fit front mud flap.