Cover - Squab - Rear Single Seat - 3 Door

78.90.85 Cover - Squab - Rear Single Seat - 3 Door

Remove

1. Remove rear seat assembly.







2. Remove 2 screws securing console cover and remove cover.







3. Remove 4 screws and remove rear seat centre console.
4. Remove 4 screws securing end covers and remove covers.
5. Remove 4 Torx bolts and remove squab assembly from cushion assembly.







6. Release back board assembly from squab frame and remove back board.







7. Remove head restraint
8. Release bottom of squab cover from frame.
9. Release sides of squab cover from frame.







10. Raise cover and pad to access head restraint guide tubes.
11. Remove guide tubes.
12. Release cover from top of frame.







13. Remove cover and pad.







14. Release cover from pad, remove and discard 5 hog rings.
15. Remove cover from pad.

Refit

1. Position cushion cover to pad and secure with hog rings.
2. Fit cover to pad.
3. Secure cover to top of frame.
4. Fit guide tubes.
5. Secure sides and bottom of cover to frame.
6. Fit head restraint.
7. Fit cushion to squab and tighten Torx bolts to 28 Nm (21 lbf.ft).
8. Position back board and secure to frame.
9. Fit end covers and tighten screws.
10. Position rear seat console and secure with screws.
11. Position console cover and secure with screws.
12. Fit rear seat.