Crankshaft Front Oil Seal

Crankshaft Front Oil Seal

Service Repair No - 12.21.14.01

Remove
1. Remove camshaft timing belt.





2. Remove crankshaft drive gear.





3. Fit thrust button, LRT-12-201 to end of crankshaft.
4. Screw LRT-12-200 into crankshaft front oil seal,
5. Tighten center bolt of LRT-12-200to remove oil seal.
6. Remove and discard oil seal from special tool.
7. Remove thrust button from crankshaft.

Refit
1. Using a lint free cloth, thoroughly clean oil seal recess in oil pump and running surface on crankshaft.
2. Fit oil seal guide from seal kit, over end of crankshaft.





3. Position new seal on crankshaft up against oil pump housing. Drift seal into place using tool LRT-12-202.
4. Remove LRT-12-202 and oil seal guide from crankshaft.
5. Clean crankshaft gear and wipe end of crankshaft.
6. Fit drive gear to crankshaft.
7. Fit camshaft timing belt.