Hard Top Position Switch / Sensor: Service and Repair

Microswitch - Hardtop Sensing - 3 Door

Service Repair No - 86.25.46

Remove
1. Remove hard-back or soft-back.
2. Remove RH rear quarter upper trim casing.





3. Remove 2 bolts securing soft-back support bracket.
4. Disconnect micro-switch multiplug and release from retainer.





5. Remove peg securing micro-switch, and remove micro-switch.
6. Collect micro-switch seal.

Refit
1. Locate micro-switch seal, position micro-switch and secure with peg.
2. Connect multiplug and secure to retainer.
3. Position soft-back support bracket, fit bolts and tighten to 25 Nm (18 ft. lbs.).
4. Fit RH rear quarter upper trim casing.
5. Fit hard-back or soft-back.