Mounting Rubbers - Anti-Roll Bar - Set

Remove
1. Raise front of vehicle.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.





2. Remove 4 bolts securing anti-roll bar saddle clamps to rear beam and collect saddle clamps.
3. Remove anti-roll bar rubbers.

Refit
1. Clean anti-roll bar, saddle clamps and mating faces.
2. Fit anti-roll bar rubbers.
3. Fit saddle clamps, fit bolts and tighten to 23 Nm (17 ft. lbs.)
4. Remove stands and lower vehicle.