Glass - Tail Door

Glass - Tail Door

Service Repair No - 76.31.20

Remove
1. Remove tail door plastic sheet.





2. Disconnect 2 Lucars from heater element.
3. Lower screen to access clamp bolts.
4. Loosen both clamp bolts, release and remove rear screen.

Refit





1. Position screen to door and align in clamps using timing marks on screen.
2. Ensure glass is fully pushed down in clamp closest to door hinge, then tighten clamp bolt.
3. Position screen horizontally by lifting clamp closest to door latch so that screen heater element is aligned with waist seal.
4. Tighten clamp bolts to 8 Nm (6 ft. lbs.).
5. Raise screen and connect Lucars to screen heater element.
6. Ensure a 5mm equal gap exists between screen and both 'E' post finishers. If required, adjust screen again using timing marks.
7. Loosen lower adjuster lock nuts.
8. Loosen pre-load screws so screen clears seal.
9. Adjust pre-load screws until screen is just in contact with seal.
10. Adjust pre-load screws until screen applies a 1mm pre-load on seal.
11. Ensure there is full screen to seal contact.
12. Lower glass and tighten lock nuts to 14 Nm (10 ft. lbs.).
13. Recheck pre-load.
14. Raise and lower screen to confirm correct alignment.
15. Fit tail door plastic sheet.