Oil Pump: Service and Repair

Oil Pump

Service Repair No - 12.60.26

Removal
1. Disconnect the battery ground cable.
2. Remove the timing drive components.
3. Remove the sump pan.





4. Remove the oil strainer pick up assembly.
^ Remove the 3 bolts.
^ Remove and discard the O-ring seal.





5. Remove the oil pump assembly.
^ Remove the 4 bolts.
^ Remove and discard the gasket.
^ Clean the component mating faces.

Installation
1. Install the oil pump assembly.
^ Install the new gasket.
^ Tighten the bolts to 10 Nm (7 ft. lbs.).
2. Install the oil strainer pick up assembly.
^ Install the O-ring seal.
^ Tighten the bolt to 6 Nm (4.4 ft. lbs.).
^ Tighten the bolts to 10 Nm (7 ft. lbs.).
3. Install the sump pan.
4. Install the timing drive components.