Oil Temperature Sensor/Switch: Service and Repair

Oil Temperature Sensor

Service Repair No - 12.60.65

Removal
1. Disconnect the battery ground cable.
2. Remove the radiator access panel.
^ Remove the 4 bolts.





CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.

3. Remove the oil temperature sensor.
^ Disconnect the electrical connector.
^ Position a container to collect the fluid.





Installation
1. To install, reverse the removal procedure.
^ Tighten the oil temperature sensor to 20 Nm (15 ft. lbs.).
^ Tighten the bolts to 10 Nm (7 ft. lbs.).

2. Check and top-up the engine oil.