Differential Temperature Sensor/Switch: Service and Repair

Rear Axle Oil Temperature Sensor

Service Repair No - 51.15.06

Removal

1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
2. Drain the differential lubricant.





3. Disconnect the electrical connector.
^ Release the wiring harness retaining clip.





4. Remove the oil temperature sensor.
^ Remove and discard the O-ring seal.

Installation
1. Clean the component mating faces.
2. Install the oil temperature sensor.
^ Tighten to 22 Nm (16 ft. lbs.).
3. Connect the electrical connector.
^ Secure the wiring harness clip.
4. Fill the differential with the correct amount of lubricant.