Front Seat

Front Seat

Service Repair No - 78.10.44/99

Removal

WARNING:
^ It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^ Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

1. Make the SRS system safe.

2. NOTE: Torx bolts may be re-used.

Release the front seat.
^ Remove the bolt covers.
^ Remove and the 5 Torx bolts.







3. Release the safety belt lower anchor from the seat.
^ Remove the bolt cover.
^ Passenger side, disconnect the electrical connector.
^ Remove and discard the Torx bolt.







4. With assistance, remove the front seat.
^ Protect the rocker panel.
^ Remove the bolt.
^ Disconnect the 2 electrical connectors.
^ Release the 2 wiring harness clips.







Installation

1. With assistance, install the front seat.
^ Connect the electrical connectors.
^ Secure the wiring harness clips.

2. Attach the safety belt lower anchor to the seat.
^ Tighten the new Torx bolt to 40 Nm (30 lb.ft).
^ Passenger side, connect the electrical connector.
^ Install the bolt cover.

3. Secure the front seat.
^ Tighten the Torx bolts to 40 Nm (30 lb.ft).
^ Install the bolt covers.

4. Connect the battery ground cable.