Instrument Panel Passenger Side Reinforcement

Instrument Panel Passenger Side Reinforcement (76.46.32)

Removal

1. Remove the instrument panel center reinforcement.
2. Remove the PAD switch.
3. Remove the glove compartment.
4. Remove the closing trim panel.
^ Release the clip.
^ Remove the 2 screws.
^ Disconnect the electrical connector.







5. Remove the passenger side footwell duct.
^ Remove the clip.







6. Remove the stowage compartment tray.
^ Release the 4 clips.







7. Remove the instrument panel passenger side reinforcement.
^ Remove the 11 Torx screws.
^ Disconnect the electrical connector.







8. NOTE: Do not disassemble further if the component is removed for access only.

Remove the glove compartment lamp.







9. Remove the glove compartment damper.
^ Remove the Torx screw.







10. NOTE: Note the position of the hinge pin and spring prior to removal.

Remove the stowage compartment lid.
^ Remove the 2 hinge pins.
^ Release the 2 hinge springs.
^ Remove the Torx screw and remove the damper.







11. Remove the glove and stowage compartment strikers.
^ Remove the 4 Torx screws.







Installation

1. Install the glove compartment damper.
^ Tighten the Torx screw.

2. Install the stowage compartment lid.
^ Install the damper and tighten the Torx screw.
^ Attach the hinge springs.
^ Install the hinge springs.

3. Install the glove and stowage compartment strikers.
^ Tighten the screws.

4. Install the glove compartment lamp.
5. Install the instrument panel passenger side reinforcement.
^ Connect the electrical connector.
^ Tighten the Torx screws.

6. Install the passenger side footwell duct.
^ Install the clip.

7. Install the closing trim panel.
^ Connect the electrical connector.
^ Secure the clip.

8. Install the stowage compartment tray.
^ Secure the clips.

9. Install the glove compartment.
10. Install the PAD switch.
11. Install the instrument panel center reinforcement.