Ignition Coil: Service and Repair
Ignition Coil
Service Repair No - 18.20.32
Removal
1. Disconnect the battery ground cable.
2. Remove the engine cover.
3. Disconnect the ignition lead from the coil.
4. Remove the ignition coil.
^ Remove the bolt.
^ Remove the stud.
^ Disconnect the ignition coil electrical connector.
Installation
1. To install, reverse the removal procedure.
^ Connect the ignition coil electrical connector.
^ Tighten the bolt to 6 Nm (4 ft. lbs.).
^ Tighten the stud to 6 Nm (4.4 ft. lbs.).