Driver Air Bag Module

Driver Air Bag Module

Service Repair No - 76.74.01

Special Service Tools

Driver Air Bag Module Remover - 501-106:

Removal

WARNING:
^ It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^ Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.

1. Disconnect the battery ground cable.
2. Make the SRS system safe.
3. Remove the driver air bag module.
^ Using the special tool, release the clip.
^ Repeat the above procedure for the other side.
^ Disconnect the ground cable.
^ Release the clips and disconnect the 2 electrical connectors.





Installation

WARNING: The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.

1. Attach the driver air bag module.
^ Connect the ground cable.
^ Connect the electrical connectors.

WARNING: Driver air bag module installation can be confirmed by hearing 2 audible clicks, 1 for each spring. The module edges should also be flush with the steering wheel.

2. Install the driver air bag module.
^ Align the module to the steering wheel.
^ Make sure the wires are not trapped behind the module.
^ Align the locating pins and springs.