Rear Side Air Curtain Module

Rear Side Air Curtain Module

Removal

WARNING:
^ It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^ Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.

1. Disconnect the battery ground cable.
2. Make the SRS system safe.
3. Remove the headliner.
4. Remove the side air curtain module.
^ Disconnect the electrical connector.
^ Remove the 5 Torx screws.
^ Release the retaining strap.





Installation
1. Install the side air curtain module.
^ Tighten the Torx screws to 10 Nm (7 ft. lbs.).
^ Connect the electrical connector.
^ Secure the retaining strap.

2. Install the headliner.
3. Connect the battery ground cable.