Front Door Side Impact Sensor
Front Door Side Impact Sensor
Removal
WARNING:
^ It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^ Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.
NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.
1. Make the SRS system safe.
2. Remove the front door trim panel.
3. Remove the front door side impact sensor.
^ Disconnect the electrical connector.
^ Remove the 2 Torx bolts.
Installation
1. Install the front door side impact sensor.
^ Tighten the Torx bolts to 8 Nm (6 ft. lbs.).
^ Connect the electrical connector.
2. Install the front door trim panel.