Front Door Window Regulator: Service and Repair

Front Door Window Regulator and Motor

Service Repair No - 86.25.03

Removal

1. Remove the front door trim panel.
2. Remove the front door window glass.
3. Remove the speaker.
^ Disconnect the electrical connector.
^ Remove the 4 screws.







4. Remove the glass guide channel.
^ Release the channel lining.
^ Remove the bolt.







5. NOTE: Rotate the assembly within the aperture through 90 degrees and release the upper edge from the rear side of the aperture first.

Remove the window motor and regulator assembly.
^ Disconnect the electrical connector.
^ Remove the 4 bolts.
^ Remove the 2 nuts.







Installation

1. Install the window motor and regulator assembly.
^ Tighten the bolts and nuts to 10 Nm (7 lb.ft).
^ Connect the electrical connector.

2. Install the glass guide channel.
^ Tighten the bolt to 10 Nm (7 lb.ft).
^ Install the channel lining.

3. Install the speaker
^ Align the door wiring harness clip.
^ Tighten the screws.
^ Connect the electrical connector.

4. Install the front door window glass.
5. Install the front door trim panel.