Tail Lamp: Service and Repair

Rear Lamp Assembly

Removal
1. Open the liftgate and tailgate.

CAUTION: Always protect paintwork and glass when removing exterior components.

2. Remove the rear lamp assembly.
^ Remove the 2 screws.
^ Release the 2 clips.
^ Disconnect the electrical connector.





NOTE:
^ Do not disassemble further if the component is removed for access only.
^ Note the fitted position.

3. Remove the wiring harness.
^ Release the wiring harness from the 2 clips.
^ Release the 6 bulb holders.
^ Release the electrical connector.





Installation
1. Install the wiring harness.
^ Install the 6 bulb holders.
^ Install the electrical connector.
^ Secure the wiring harness in the clips.

2. Install the rear lamp assembly.
^ Connect the electrical connector.
^ Secure with the 2 clips.
^ Tighten the screws.

3. Close the tailgates.