Passenger Air Bag Module

Passenger Air Bag Module

Service Repair No - 76.74.02

Removal

WARNING:
^ It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^ Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

1. Disconnect the battery ground cable.
2. Make the SRS system safe.
3. Remove the instrument panel upper section.
4. Remove the passenger air bag module.
^ Remove the 4 nuts.





NOTE: Do not disassemble further if the component is removed for access only.

5. Remove the passenger air bag module bracket.
^ Remove the 2 nuts.





Installation
1. Install the passenger air bag module bracket.
^ Tighten the nuts to 10 Nm (7 ft. lbs.).

2. Install the passenger air bag module.
^ Tighten the nuts to 10 Nm (7 ft. lbs.).

3. Install the instrument panel upper section.