Interior - Upper Glove Compartment Rattles

No: LTB00296 (Issue 1)

18 FEB 2011

SECTION: 501

Upper Glove Compartment Rattle

AFFECTED VEHICLE RANGE:
LR3 (LA) VIN: 5A000360 - 9A513325
Model Year: 2005 - 2009

Range Rover Sport (LS) VIN: 6A900290 - 7A999999
7A100000 - Onwards
Model Year: 2006 - Onwards

CONDITION SUMMARY:

Situation:

The upper glove compartment may exhibit a rattle. This may be caused by the upper glove compartment lid bump stop(s) being worn.

Action:

In the event of a customer concern of the above, refer to the Repair Procedure outlined below to install new upper glove compartment bump stops.





PARTS INFORMATION

TOOLS:

Refer to Workshop Manual for any required special tools





WARRANTY:

NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always refer to DDW to obtain the latest repair time.

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

REPAIR PROCEDURE

INSTALL UPPER GLOVE COMPARTMENT LID BUMP STOPS

1. Open the upper glove compartment lid





2. Remove the existing right-hand (RH) bump stop from the compartment liner. (Figure 1)

CAUTION:
Do not damage surrounding area.





3. Using a small screwdriver, carefully install the new bump stop. (Figure 2)





4. Twist! pull the bump stop lightly, ensuring it is fully seated. (Figure 3)

5. Repeat steps 2 - 4 on the left-hand (LH) bump stop.