Driver Air Bag Module

Driver Air Bag Module

Special Service Tools







501-106
Remover, Driver Air Bag

Removal

1. Disconnect the battery ground cable.
2. Make the SRS system safe.
3. Carefully release the 2 clips.
Using the special tool, remove the driver air bag module.

Special Service Tools: Remover, Driver Air Bag

4. WARNING: Do not probe supplemental restraint system (SRS) electrical connectors.

Disconnect the 3 electrical connectors.







Installation

1. WARNING:
^ The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^ Driver air bag module installation can be confirmed by hearing 2 audible clicks, 1 for each spring. The module edges should also be flush with the steering wheel.

NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.

To install, reverse the removal procedure.