Radiator Cooling Fan: Service and Repair

Cooling Fan

Removal

1. WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.

2. CAUTION: After switching off the ignition, wait for 2 minutes before disconnecting the battery. Failure to wait for 2 minutes will damage the navigation computer.

Disconnect the battery ground cable.

3. Remove the intake manifold.
4. Release the A/C and power steering pipes.





5. Remove the A/C line support bracket.
6. Remove the A/C compressor, lower support bracket.





7. Remove the A/C compressor, upper support bracket.





8. Release the accessory drive belt tension.





9. Release the A/C compressor and position aside.





10. Disconnect the cooling fan control electrical connector.





11. Release the cooling fan wiring harness.
12. Remove the cooling fan assembly.





Installation

1. Install the cooling fan assembly.
2. Install the A/C compressor.

Torque:
25 Nm

3. Install the A/C compressor, upper support bracket.

Torque:
M10. 45 Nm
M8. 25 Nm
M6. 10 Nm

4. Install the accessory drive belt.
5. Install the A/C compressor, lower support bracket.

Torque:
25 Nm

6. Install the A/C line support bracket.

Torque:
10 Nm

7. Secure the A/C pipes.
8. Secure the cooling fan harness.
9. Connect the cooling fan electrical connector.
10. Install the intake manifold.
11. Connect the battery ground cable.