Electronic Brake Control Module: Service and Repair

Anti-Lock Brake System (ABS) Module

Service Repair No - 70.25.12

Removal

CAUTION: Extreme cleanliness must be exercised when handling these components.

CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.

All vehicles

1. WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.

2. Disconnect the battery ground cable.
3. Remove the battery tray.

Right-hand drive vehicles

4. Remove the plenum chamber panel.

Left-hand drive vehicles

5. Remove the windshield wiper motor and linkage.

6. CAUTION: Make sure that all openings are sealed.

All vehicles

7.

Left-hand drive vehicles

10. CAUTION: Be prepared to collect escaping fluids.

CAUTION: Make sure that all openings are sealed.

Right-hand drive vehicles

11. CAUTION: Be prepared to collect escaping fluids.

CAUTION: Make sure that all openings are sealed.

All vehicles

12. CAUTION: Be prepared to collect escaping fluids.

CAUTION: Make sure that all openings are sealed.

Installation

All vehicles

1. Install the ABS module.

Torque:
10 Nm

2. Install the brake fluid tubes.

Torque:
15 Nm

3. Install the battery tray support.

Torque:
M6. 10 Nm
M8. 25 Nm

Left-hand drive vehicles

4. Connect the brake booster vacuum line.

All vehicles

5. Install the ECM.
6. Secure the vacuum line and harness.

Left-hand drive vehicles

7. Install the windshield wiper motor and linkage.

Right-hand drive vehicles

8. Install the plenum chamber panel.

All vehicles

9. Install the battery tray.
10. Connect the battery ground cable.
11. Bleed the brake system.
12. If a new component has been installed, configure using Land Rover approved diagnostic equipment.