Installation

Transmission - 3.2L

1. Install the TCM

Torque:
24 Nm

2. Install the transmission selector lever.

Torque:
13 Nm

3. Install the transmission fluid cooler.

Torque:
10 Nm

4. Remove the torque converter retainer.

5. CAUTION: Make sure that the torque converter remains in the transmission.

CAUTION: Make sure that the component is correctly located on the locating dowels.

CAUTION: Make sure that the mating faces are clean and free of corrosion and foreign material.

NOTE: This step requires the aid of another technician.

Install the transmission and converter.

6. Install the transmission retaining bolts.

Torque:
47 Nm

7. Remove the transmission support.
General Equipment: Powertrain Jack

8. Install the engine mount bracket.

Torque:
90 Nm

9. Install the engine mount LH.

Torque:
175 Nm

10. WARNING: Make sure that new nuts are installed.

Install the bracket.
Torque:
M12. 80 Nm
M8. 25 Nm

11. Remove the engine support.
12. Secure and connect the selector lever cable.
13. Install the transmission oil cooler.
14. Connect the transmission fluid cooler coolant hoses.
15. Install the power steering pump.

Torque:
25 Nm

16. Install the coolant pump inlet pipe.

Torque:
10 Nm

17. Attach the flexplate.

Torque:
47 Nm

18. Install the access cover.

Torque:
10 Nm

19. Remove the crankshaft locking tool.

20. CAUTION: Make sure that the mating faces are clean and free of foreign material.

NOTE: This step requires the aid of another technician.

Install the power transfer unit.

Torque:
65 Nm

21. Install the power transfer unit support bracket.

Torque:
65 Nm

22. Install both the halfshafts.
23. Install the RH halfshaft support.

Torque:
25 Nm

24. CAUTION: Make sure that new bolts are installed.

Torque:
Stage 1. 45 Nm
Stage 2. 80°

25. Install the crankshaft front oil seal.
26. Install the front subframe.
27. Install the accessory drive pulley.
28. Install the starter motor.
29. Connect the battery ground cable and install the cover.
30. Fill and bleed the cooling system.
31. Refill the transmission with fluid.
32. If a new component is to be installed, configure using Land Rover approved diagnostic equipment.