Quarter Window Glass: Service and Repair

Rear Quarter Window Glass

Removal

1. Remove the rear quarter trim panel.

2. WARNING: Make sure that a new bolt is installed.

Remove the C-pillar trim panel.

Torque: 3 Nm





3. Remove the D-pillar trim panel.





4. Remove the rear quarter panel moulding.
5. Cut the seal from the rear quarter glass.





6. Feed the glazing cutting wire around all the glass.
Pull glazing wire through windshield sealant to the inside of the vehicle.





7. WARNING: Wear safety goggles and protective gloves.

CAUTION: Protect the surrounding paintwork to avoid damage.

Use the glazing cutting wire to cut the sealant.

Installation

1. Apply etch primer to any bare metal.
2. Apply primer over the etch primer.
3. Apply glass primer to the sealant face on the rear quarter window glass and allow to cure.
4. Apply activator over the old sealant on the rear quarter window glass and allow to cure.
5. Fit a pre-cut nozzle to the sealer cartridge, remove the lid, shake out the crystals and fit the cartridge to the applicator gun.
Modify the nozzle to achieve a bead section in the shape of a right angle triangle with a base of 8 mm and a vertical height of 12 mm.

6. Apply a continuous bead of sealant to the glass.





7. With assistance, install the window glass.
Lightly press the window glass to seat the sealer.
Secure the rear quarter window glass in position using tape.

8. Test the sealer for leaks, apply additional sealer if necessary. If water is used, allow sealer to dry before testing.
Spray water around the glass and check for leaks. Mark any area that leaks. Dry the glass and sealer then apply additional sealer.

9. Install the rear quarter panel moulding.

10. WARNING: Make sure that a new bolt is installed.

Install the C-Pillar trim panel.

11. Install the D-pillar trim panel.
12. Install the rear quarter trim panel.