Rear Door Window Regulator: Service and Repair

Rear Door Window Regulator and Motor

Special Service Tools





501-114
Release Lever, Door Glass

Removal

NOTE: If possible, lower the window glass by approximately one third of its travel.

1. Disconnect the battery ground cable.
2. Remove the rear door module.
3. Carefully remove the outer waist seal.





4. Release the door window glass from the window lift mechanism. Raise the glass and secure it to the top of the door frame.
Special Service Tools: Release Lever, Door Glass





5. Secure the glass to the top of the frame.





6. Remove the window motor and regulator assembly.
Rotate the assembly within the door through 90 degrees and remove the upper edge from the aperture first.





Installation

1. Install the window motor and regulator assembly. Tighten the nuts and the bolts.

Torque: 10 Nm

2. Secure the door window glass to the window lift mechanism.
3. Install the outer waist seal and secure with the Torx screw.
4. Install the rear door module.
5. Connect the battery ground cable.