Trunk / Liftgate: Service and Repair

Liftgate

Service Repair No - 76.28.29

Removal

1. Open the liftgate and tailgate.
2. Disconnect the battery ground cable.
3. Remove the liftgate upper trim panel.
^ Release the 4 clips.







4. Remove the liftgate side trim panel.
^ Release the 5 clips.
^ Repeat the above procedure for the other side.







5. Remove the rear headliner trim panel.
^ Release the 7 clips.
^ Disconnect the electrical connector.







6. Disconnect the washer jet hose.
^ Release the grommet.

7. Release the liftgate wiring harness.
^ Disconnect the 2 electrical connectors.
^ Release the grommet.







8. With assistance, remove the liftgate assembly.
^ Release the clips and disconnect the struts.
^ Remove the 2 bolts.







Installation

1. With assistance, install the liftgate assembly.
^ Tighten the bolts to 40 Nm (30 lb.ft).
^ Connect the struts and secure with the clips.

2. Attach the liftgate wiring harness.
^ Install the grommet.
^ Connect the electrical connectors.

3. Connect the washer jet hose.
^ Install the grommet.

4. Install the liftgate side trim panel.
^ Secure with the clips.
^ Repeat the above procedure for the other side.

5. Install the liftgate upper trim panel.
^ Secure with the clips.

6. Connect the battery ground cable.
7. Check and adjust the liftgate to roof panel profile.