Operation CHARM: Car repair manuals for everyone.

Floor Console



Floor Console (76.25.01)

Removal

1. Remove the floor console upper panel.
2. Remove the cigar lighter assembly closing panel.
^ Release the 4 clips.







3. Release the floor console wiring harness and disconnect the 5 electrical connectors.
4. Remove the floor console.
^ Move the front seats fully forwards.
^ Remove both rear Torx bolt covers.
^ Remove the 4 Torx bolts.







5. NOTE: Do not disassemble further if the component is removed for access only.

Remove the floor console lid.
^ Open the lid.
^ Remove the 2 Torx bolts.
^ Remove the 2 covers.







6. Remove the floor console stowage compartment.
^ Remove the 2 Torx screws.
^ Release the 5 clips.







7. Remove the auxiliary socket panel.
^ Release the 2 clips.
^ Disconnect the 2 electrical connectors.







8. Remove the floor console register trim panel.
^ Release the 6 clips.
^ Remove the screw.







9. Remove the cup holder.
^ Release the 2 clips.







10. Remove the wiring harness.
^ Release the 3 clips.







Installation

1. Install the wiring harness.
^ Secure the clips.

2. Install the cup holder.
^ Secure with the clips.

3. Install the floor console register trim panel.
^ Secure with the clips.
^ Install the screw.

4. Install the auxiliary socket panel.
^ Connect the electrical connectors.
^ Secure with the clips.

5. Install the floor console stowage compartment.
^ Secure the clips.
^ Tighten the Torx screws.

6. Install the floor console lid.
^ Install the covers.
^ Tighten the Torx bolts to 3 Nm (2 lb.ft).

7. Install the floor console.
^ Tighten the Torx bolts to 10 Nm (7 lb.ft).
^ Install the Torx bolt covers.
^ Connect and secure the electrical connectors.

8. Install the cigar lighter assembly closing panel.
^ Secure with the clips.

9. Install the floor console upper panel.