C-Pillar Lower Trim Panel
C-Pillar Lower Trim Panel (76.13.34)
Removal
1. Fold down the rear seat backrest.
2. Release the door aperture weatherstrip.
3. Release the safety belt anchor.
^ Remove and discard the bolt.
4. Release the tailgate aperture seal.
5. Remove the support spigot from the tailgate.
^ Release the clip.
6. Remove the C-pillar lower trim panel.
^ Remove the Torx screw.
^ Release the 8 clips.
^ Disconnect the 2 electrical connectors.
7. NOTE: Do not disassemble further if the component is removed for access only.
Remove the stowage tray.
^ Release the cover.
8. Remove the audio control switch.
^ Release the 2 clips.
9. Remove the accessory socket.
Installation
1. Install the accessory socket.
2. Install the audio control switch.
^ Secure the clips.
3. Install the stowage tray.
^ Install the cover.
4. Install the C-pillar lower trim panel.
^ Install the clips.
^ Tighten the Torx screw to 8 Nm (6 lb.ft).
^ Connect the electrical connector.
5. Install the support spigot to the tailgate.
^ Install the clip.
6. Install the tailgate aperture seal.
7. Install the safety belt anchor.
^ Tighten the Torx bolt to 45 Nm (33 lb.ft).
8. Install the door aperture weatherstrip.
9. Return the seat backrest to the upright position.