Rear Door Trim Panel

Rear Door Trim Panel

Removal

CAUTION: Release the 2 lower clips first, using the access holes.

1. Remove the grab handle cover.
^ Release the 4 clips.

2. Remove the screw securing the door latch remote release.
^ Release the screw cover.





3. Release the rear door trim panel.
^ Remove the 6 screws.
^ Release the 13 clips.





4. Disconnect the door latch remote release cable.





5. Remove the rear door trim panel.
^ Disconnect the 4 electrical connectors.





NOTE: Do not disassemble further if the component is removed for access only.

6. Remove the rear door latch remote control handle.
^ Starting at the lower edge, carefully release the remote handle.





7. Remove the puddle lamp.
^ Carefully release the lamp.





8. Remove the window control switch.
^ Carefully release the clips.

9. Remove the tweeter.





10. Remove the 9 clips.





Installation
1. Install the window control switch.
^ Secure with the clips.

2. Install the tweeter.
^ Secure with the clips.

3. Install the puddle lamp.
4. Install the rear door latch remote control handle.
5. Install the clips.
6. Install the rear door trim panel.
^ Connect the electrical connectors.
^ Connect the door latch remote control cable.
^ Secure with the clips.
^ Tighten the screws.

7. Install the screw securing the door latch remote release.
^ Install the grab handle cover.

8. Install the grab handle cover.