Rear Quarter Trim Panel

Rear Quarter Trim Panel (76.13.12)

Removal

1. Fold down the rear seat backrest.
2. Release the door aperture weatherstrip.







3. Release the safety belt anchor.
^ Remove and discard the bolt.







4. Release the tailgate aperture seal.







5. Remove the support spigot from the tailgate.
^ Release the clip.







6. Remove the rear quarter trim panel.
^ Remove the Torx screw.
^ Release the 8 clips.
^ Disconnect the 2 electrical connectors.







7. NOTE: Do not disassemble further if the component is removed for access only.

Remove the stowage tray.
^ Release the cover.

8. Remove the audio control switch.
^ Release the 2 clips.

9. Remove the accessory socket.







Installation

1. Install the accessory socket.
2. Install the audio control switch.
^ Secure the clips.

3. Install the stowage tray.
^ Install the cover.

4. Install the rear quarter trim panel.
^ Install the clips.
^ Tighten the Torx screw to 8 Nm (6 lb.ft).
^ Connect the electrical connector.

5. Install the support spigot to the tailgate.
^ Install the clip.

6. Install the tailgate aperture seal.
7. Install the safety belt anchor.
^ Tighten the Torx bolt to 40 Nm (30 lb.ft).

8. Install the door aperture weatherstrip.
9. Return the seat backrest to the upright position.