Roof Opening Panel Motor

Roof Opening Panel Motor

Removal
1. Remove both A-pillar upper trim panels.
2. Remove both B-pillar upper trim panels.
3. Remove the front overhead console.
^ Carefully release the 7 clips.
^ Disconnect the electrical connector.





4. Remove the sun visor.
^ Remove the cover.
^ Remove the 2 screws.
^ Release from the clip.
^ Disconnect the electrical connector.
^ Repeat the above procedure for the other side.





5. Remove the sun visor retaining clip.
^ Release the screw cover.
^ Remove the screw.
^ Repeat the above procedure for the other side.





6. Remove the passenger assist handle.
^ Release the 2 screw covers.
^ Remove the 2 screws.
^ Repeat the above procedure for the other side.





7. Lower the headliner for access.
^ Release the 4 clips.





8. Remove the roof opening panel motor.
^ Disconnect the electrical connector.
^ Remove the 3 Torx screws.
^ Remove the spacer.





Installation
1. Install the roof opening panel motor.
^ Install the spacer.
^ Tighten the Torx screws to 4 Nm (3 ft. lbs.).
^ Connect the electrical connector.

2. Position the headliner.
^ Secure with the clips.

3. Install the passenger assist handles.
^ Install the screws.
^ Secure the screw covers.

4. Install the sun visors.
^ Install the clips.
^ Install the screws.
^ Install the screw covers.
^ Connect the electrical connectors.

5. Install the front overhead console.
^ Connect the electrical connector.
^ Carefully secure the clips.

6. Install both B-pillar upper trim panels.
7. Install both A-pillar upper trim panels.
8. Using T4, configure a new roof opening panel motor.
9. If the battery has been disconnected, the one touch and anti-trap function will become inoperative. Close the roof opening panel and continue to hold the switch for a further 20 seconds to allow the sunroof to complete a full cycle. This will complete the roof opening panel calibration routine and reset these functions.