Camshaft Drive Cassette RH
Camshaft Drive Cassette RHService Repair No - 12.65.37
Special Service Tools
Removal
1. Disconnect the battery ground cable.
2. Remove the RH cylinder head assembly.
3. Remove the torque converter flexplate.
4. Remove the cylinder block jackshaft plug.
^ Drift to release.
5. Using the special tool, remove the RH cassette jackshaft drive, sprocket bolt.
^ Remove and discard the Torx bolt.
6. Remove the camshaft drive cassette assembly.
^ Remove the bolt retaining the chain guide.
^ Remove and discard the O-ring seal.
7. NOTE: Do not disassemble further if the component is removed for access only.
Disassemble the cassette assembly.
^ Release the cable tie.
^ Remove the sprockets and the chain.
^ Clean and inspect the components for deterioration.
Installation
1. Assemble the cassette assembly.
^ Install the chain and the sprockets.
^ Secure with a cable tie.
2. Install the camshaft drive cassette assembly.
^ Install a new O-ring seal.
^ Tighten the bolt to 12 Nm (9 ft. lbs.).
3. Using the special tool, tighten the new jackshaft sprocket bolt to 40 Nm (30 ft. lbs.), then a further 45 degrees.
4. Install the cylinder block jackshaft plug.
^ Clean the component mating faces.
5. Install the torque converter flexplate.
6. Install the cylinder head RH assembly.
7. Connect the battery ground cable.