Operation CHARM: Car repair manuals for everyone.

C-Pillar Side Impact Sensor



C-Pillar Side Impact Sensor

Removal

WARNING:
^ It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^ Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.


NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.

1. Make the SRS system safe.
2. Remove the C-pillar lower trim panel.
3. Remove the side impact sensor.
^ Remove the 2 Torx bolts.
^ Disconnect the electrical connector.





Installation
1. Install the side impact sensor.
^ Tighten the Torx bolts to 8 Nm (6 ft. lbs.).
^ Connect the electrical connector.

2. Install the C-pillar lower trim panel.