Front Fender: Service and Repair

Fender

Service Repair No - 76.10.24

Removal

1. Disconnect the battery ground cable.
2. Remove the plenum chamber panel.
3. Remove the headlamp assembly.
4. Remove the fender splash shield.
5. Remove the fender moulding.
6. Remove the fender lower moulding.
^ Release the 4 clips.







7. Remove the fender air intake grille.
^ Release the 4 clips.
^ Remove the air ducting.







8. Remove the front fender.
^ Remove the 6 Torx bolts.
^ Remove the nut.







9. NOTE: Do not disassemble further if the component is removed for access only.

Remove the fender rear trim.
^ Remove the 3 clips.







Installation

1. Install the fender rear trim.
^ Secure in the 3 clips.

2. Install the front fender.
^ Install the bolts and tighten to 10 Nm (7 lb.ft).
^ Install the nut and tighten to 10 Nm (7 lb.ft).

3. Install the fender air intake grille.
^ Install the air ducting.

4. Install the lower fender moulding.
^ Secure in the clips.

5. Install the fender moulding.
6. Install the fender splash shield.
7. Install the headlamp assembly.
8. Install the plenum chamber panel.
9. Connect the battery ground cable.