Roof Opening Panel Module

Roof Opening Panel Module

Removal
1. Remove the rear overhead console.
^ Carefully release the 9 clips.
^ Disconnect the 2 electrical connectors.





2. Remove the roof opening panel module.
^ Slide the module to the LH side to release it from the bracket.
^ Disconnect the 2 electrical connectors.





Installation
1. Install the roof opening panel module.
^ Connect the electrical connectors.
^ Secure the module to the bracket.

2. Install the rear overhead console.
^ Connect the electrical connectors.
^ Carefully secure the clips.

3. Using T4, configure a new roof opening panel module.
4. If the battery has been disconnected, the one touch and anti-trap function will become inoperative. Close the roof opening panel and continue to hold the switch for a further 20 seconds to allow the sunroof to complete a full cycle. This will complete the roof opening panels calibration routine and reset these functions.