Exhaust Manifold RH

Exhaust Manifold RH

Service Repair No - 30.15.11

Removal
1. Disconnect the battery ground cable.
2. Remove the exhaust system.
3. Remove the fender splash shield.





4. NOTE: The heatshield consists of 3 parts.

Remove the upper suspension arm and brake line heat shields for access.
^ Remove the 3 nuts.
^ Remove the 3 bolts.





5. Remove the exhaust manifold.
^ Remove the 8 bolts.
^ Collect the spacers and discard the bolts.
^ Remove the gasket/heat shield retaining bolt.
^ Discard the gasket/heat shield.

Installation
1. Clean the component mating faces.





2. Install the exhaust manifold.
^ Install the gasket/heat shield.
^ Tighten the heat shield bolt to 25 Nm (18 ft. lbs.).
^ Evenly and progressively, tighten the bolts in the sequence shown to 20 Nm (15 ft. lbs.).

3. NOTE: The heatshield consists of 3 parts.

Install the upper suspension arm and brake line heat shields.
^ Install the bolts.
^ Install the nuts.
4. Install the fender splash shield.
5. Install the exhaust system.
6. Connect the battery ground cable.