Four Wheel Drive Selector Switch: Service and Repair

High/Low Range Sensor

Removal

1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
2. Remove the crossmember.





3. CAUTION: To avoid damage to the joints or gaiters, do not allow the transmission to hang on the driveshafts.

Remove the mode sensor.
^ Lower the rear of the transmission for access.
^ Disconnect the electrical connector.
^ Remove the 2 Torx bolts.

Installation
1. To install, reverse the removal procedure.
^ Clean the components.
^ Tighten the Torx bolts to 10 Nm (7 ft. lbs.).
2. Install the crossmember.
3. Use T4 to re-calibrate a new mode sensor.